Totalview® Getting Started Guide : Getting Started with TotalView Products : Setting Breakpoints and Stepping through a Program : Stepping Through a Program
Stepping Through a Program
To start and step through your program, the easiest way is to use the buttons on the Process Window’s toolbar:
 
Figure 13 – Process Window Toolbar
To start and stop your program:
Set a breakpoint, then select Go in the toolbar. Your program starts executing. Execution stops just before the line that contains a breakpoint or when you click Halt.
Select Next. TotalView starts your program, and then stops it immediately before the first statement in your main() function.
To stop a running program, select the toolbar’s Halt button. To restart a program, select the toolbar’s Restart button.
To step through your program, use the Step and Next buttons. Both tell your program to execute the current line, but when a line has a function call
Step goes into the function
Next completely executes the function
If you want to get to a line without individually stepping each line in between, select the line (not the line number) to highlight it, then click the Run To button.
To step out of a function:
If you stepped into a function and want to pop out to the statement that called it, click the Out button.
 
RELATED TOPICS 
Basic stepping commands
Using Stepping Commands” in the TotalView User Guide
Stepping in multi-process or
multi-threaded programs
Stepping Part I” and Part II” in the TotalView User Guide
Using CLI commands to step
Execution Control Commands” in the TotalView
Reference Guide